888-860-7788
Powered by removable batteries, PM10AB could be your best pain relief buddy on the trip. 2 isolated outputs allow 4 pads to be applied to 2 targeted body areas with different mode and intensity combination. Belt clip equipped.
Removable Batteries
Powered by 2 AAA Batteries. Get rid of the tangled charging cords. Convenient and travel-friendly!
Belt Clip
Attach it to your outfit with a straightforward clip. Run, jump, and stretch out like it's not even there.
Ergonomic Body Design
Easy to hold device body design also allows you single hand operation. Palm size & ultra-lightweight!
Customize your Intensity & Mode Combination
Isolated channels allow you to use different intensity & mode combinations targeted two areas simultaneously.
Targeted Muscle Improvement
10 Massage-like modes target 10 different body areas to relieve pain fast and recover soreness muscles after exercise, household, and work activities.
10
massage-Like modes
80
minute adjustable timer
20
levels of adjustable intensity
2
isolated outputs in channel A/B, both have 100% power
AAA battery – Uses 2 AAA Batteries
Adjustable mode and intensity in channel A or channel B
Easy to read animated backlit LCD Display
Automatically shut off when time is due
Belt clip equipped
Mode list
Neck, Shoulders, Wrist, Back, Elbow, Hand, Hip, Knee, Ankle, Foot.
What's in the box
1 FDA cleared Class II OTC HealthmateForever PM10AB TENS & Muscle Stimulator
4 piece self-adhesive conductive reusable gel pads
2 sets of electrode wires (3.5mm plug)
2 AAA batteries
User Manual
Warranty Card
1 Pads Holder
Tech specs
Output pulse width: 90μS ± 15%
Pulse Frequency: <100HZ
Max output amplitude: <5v (r.m.s)
3.5mm Plug
Screen size: 1.5" W x 1" L
Size: 2.75" L x 4.25" W x .75" T
Weight: 3.3 oz
Patent No: US D717458
For User Manual, please email us at support@healthmateforever.com.
How to start?
Step 1:
Connect electrode wires with the control unit.
2. Ensure that the electrode wires are fully inserted and secured.
3. Repeat steps 1 & 2 to connect another wire.
Step 2:
Connect electrode pads with wires.
1. Each wire has two leads with snap-on connectors. Snap the wire connectors onto the snap on buttons on the pads.
2. Make sure at least one pair of pads is attached to the same wire.
3. Ensure that the snap on connections are fastened.
4. Remove the plastic films on the pads.
Step 3:
Place pads on your body.
Step 4:
Turn on the control unit.
Step 5:
Adjust timer.
Step 6:
Selecting modes and intensity.
Step 7:
Turn off the device.
Step 8:
Remove the pads from your skin.
Step 9:
Take off the pads from wires. Unplug wires from device.